Test Run |
| Hanging the Filter |
|
|
|
|
|
|
Before you install the model G9956,
If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, and contact our Tech Support at (570)
To test run the air filter unit:
1.Place the air filter unit on the floor or a sturdy work bench.
1.Connect the unit to the power source.
2.Make sure you have read the safety instruc- tions at the beginning of the manual and that the air filter unit is setup properly.
3.Make sure all tools and objects used dur- ing setup are cleared away from the air filter unit.
4.Turn the air filter unit ON and switch between fan speeds.
5.Listen to and watch for abnormal noises or vibrations. The machine should run smoothly with only a small vibration in the cabinet.
6.Turn the air filter unit OFF.
Hardware Needed (not included) | Qty |
Chain, rated 150 lbs. or higher | varies |
Connecting link | 8 |
Lag eye bolts 5/16" x 3" or 4" | 4 |
Tools Needed |
|
Drill | 1 |
Drill bit 1/4" | 1 |
The double air filter may
fall and cause serious
injury if it is not properly mounted. DO NOT fasten it to sheet rock, press board, paneling or anything other than joists.
Follow these steps and refer to Figure 5 when hanging the double air filter.
Lag eyebolts | Joists |
| |
in joists |
|
Figure 5. Hanging from the joists.
Model G9956 (Mfg. since 12/09) |