SECTION 5: OPERATIONS
Operating this equipment creates the poten- tial for flying debris to cause eye injury. Always wear safety glasses when operating equipment. Everyday glasses or reading glasses only have impact resistant lenses, they are not safety glasses. Be certain the safety glasses you wear meet the appro- priate standards of the American National Standards Institute (ANSI).
Operations that gener- ate large amounts of any kind of dust may warrant the use of a respirator even though the air filter is running. The double air filter is not a substitute for a respirator!
Operations
Operating the G9956 Double Air Filter can be done in two ways. Refer to Figure 6 while follow- ing the instructions below.
For manual ON/OFF use:
1.Connect power to the double air filter.
2.Set the main (red) switch to “No Remote Control.”
3.Pull the switch chain to turn the fan ON and
OFF.
The remote control will not work when the main switch is in this position.
Model G9956 (Mfg. since 12/09)
Figure 6. The air filter control panel. For remote control ON/OFF use:
1.Connect power to the double air filter.
2.Set the main (red) switch to “Remote Control.”
3.Push the ON/HR button on the remote control to turn it on. Push OFF to turn it off.
If the fan does not start when you turn the double air filter ON, turn the switch OFF, disconnect the power and follow these steps:
•Check the breaker/reset switch located next to the start switch and reset if needed.
•Check to make sure the outlet you have plugged the filter into is in working condition. Reset its breaker if needed.
•If you are using a remote control system with this unit, double check main switch setting.
•Check batteries in the remote.
If the double air filter will not operate after the fol- lowing steps, please call customer support lines for more help.
