SECTION 4: ASSEMBLY
Beginning Assembly
! | Disconnect power to the | |||
| ||||
| machine when perform- | |||
| ing | any | maintenance, | |
| assembly | or | adjust- | |
| ments. Failure to do this | |||
| may | result in | serious | |
| personal injury. |
| ||
Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.
Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.
Some metal parts may have sharp edges on them after they are formed. Please examine the edges of all metal parts before handling them. Failure to do so could result in injury.
Most of your Model G9958 has been assembled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented here.
TOOLS REQUIRED: You will need a 12 and 14mm wrench.
Base
Start by turning the main base upside down and placing it on a level surface. Mount four of the casters to the corners with (16) 5⁄16" x 1⁄2" hex bolts as shown in Figure 3.
Figure 3. Mounting casters to main base.
Place the left and right side bases upside down and attach the remaining four casters to the cor- ners with the four mounting holes as shown in Figure 4. Use the same fasteners and procedure as on the main base.
Figure 4. Mounting casters to the side bases.
G9958 4 H.P. Dust Collector |
