Align the right and left side bases with the main base and attach them using (8) 5⁄16" x 1⁄2" hex bolts as shown in Figure 5.
Figure 5. Assembling the three base sections.
Fan/Motor Assembly
Lay the fan/motor assembly upside down and attach the four legs using (8) 5⁄16" x 1⁄2" hex bolts as shown in Figure 6.
Figure 6. Connect the fan/motor to the legs.
Turn the fan/motor assembly rightside up and place it on top of the base assembly. Line up the mounting holes in the legs with those in the base and attach using (8) 5⁄16" x 1⁄2" hex bolts as shown in Figure 7.
G9958 4 H.P. Dust Collector
Figure 7. Attach the fan/motor/leg to the base.
Collectors
Place one of the rubber gaskets on one of the two intake openings. While holding the gasket in place, attach one of the collectors to the intake opening, making sure the gasket is aligned with the mounting holes. Fasten them together using
(8) 5⁄16" x 1" hex bolts as shown in Figure 8. Repeat this procedure for attaching the second collector to the other intake opening. Make sure these bolts are fastened tight so they make a good seal.
