OPERATIONS
Loading
Use nails meeting these specifications:
Model H7943
Nail Type: Round Head
Strip Angle: 21º
Nail Diameter: 0.113" - 0.161"
Nail Length: 2"– 4"
Magazine Capacity: 66 nails.
Model H7944
Nail Type: Clipped Head
Strip Angle: 34º
Nail Diameter: 0.113" - 0.148"
Nail Length: 2"– 4"
Magazine Capacity: 90 nails.
To load nails in your nailer:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
Point the nailer away from you and others when connecting the air supply. The nailer can cycle and discharge a nail when the air supply is connected. Ignoring this warning may result in serious personal injury.
2.Slide a strip of nails into the magazine from the rear; and slide them past the nail stopper, as shown in Figure 3.
Figure 3. Loading nails in the magazine.
3.Pull the pusher to the rear of the maga- zine, as shown in Figure 4.
Figure 4. Pulling the pusher back.
4.Slide the nails forward.
5.Point the nailer away from you. Release the pusher until it contacts the nails, as shown in Figure 5. (Do not let it snap).
