Adjusting Depth
A depth adjustment device is attached to the nose for setting the nail depth.
To adjust the depth:
1.DISCONNECT NAILER FROM THE AIR SUPPLY AND POINT THE NAILER IN A SAFE DIRECTION!
2.Use a hex wrench to loosen the cap screw on the depth adjustment device (Figure 10).
Safety Nose
Cap screw
Figure 10. Depth adjustment controls.
3.Move the safety nose to adjust nail depth:
—If you want to increase the nail depth, then move the safety nose toward the magazine.
—If you want to decrease the nail depth, then move the safety nose away from the magazine.
4.Connect the nailer to the air supply, test the nail depth, and repeat this entire procedure if necessary until the nail depth is satisfactory.
H7943 /H7944 Framing Nailer
Clearing Jammed
Nails
A jammed nail must be cleared before using the nailer again.
To clear a jammed nail from the dis- charge area:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
2.Remove all nails from the magazine. (See the instructions on Page 9.)
3.Locate the opening in the underside of the nailer nose.
4.Use needle nose pliers, or a similar tool, to grab the jammed nail and pull it back and down. as shown in Figure 11.
—If you cannot remove the jammed nail in this way, then you must remove the magazine from the nailer and pull the jammed nail out the front of the magazine.
5.Throw the damaged nail away and insert a new stick of clean, undam- aged nails. DO NOT use dirty or dam- aged nails!
Jammed Nail
