Grizzly H7943/H7944 instruction manual Cleaning & Lubricating, CleaningLubricating

CLEANING & LUBRICATING

CleaningLubricating

Use an automotive grade solvent such as Sprayway C-60®(G2544 in the Grizzly catalog) to clean the nose assembly of the nailer. Always be sure that the nailer is dry before using it again.

Do not allow dust, chips, sand, etc. into the air connectors or into the body of the nailer; this may result in leaks and dam- age to the nailer and the air couplings.

Never use gasoline or other flamma- ble liquids to clean this tool. Vapors in the tool may ignite, causing the tool to explode. Ignoring this warning may lead to serious personal injury or even death!

Special pneumatic tool oil has been included with your new Grizzly nailer to help maintain its useful life. Place two to six drops of oil in the nailer air inlet (as shown in Figure 12) every 2 hours of continuous use.

Wipe off any excess oil near the nailer exhaust to avoid dust build-up. When the oil that was included with the nailer has been completely used, replace with Grizzly Model G2820 Pneumatic Tool Oil.

Another option to manual oiling would be to simply install a lubricator in your air compressor line. If your air compressor line already has a lubricator, then regular lubrication of your nailer will not be neces- sary. Just make sure there is always oil in the lubricator.

Figure 12. Lubricating the nailer at the

air inlet.

H7943 /H7944 Framing Nailer -13-