Grizzly H7943/H7944 instruction manual Compressed Air System

Compressed Air

System

Model H7943/H7944 is designed to be operated at 70–120 PSI using clean, dry, regulated, compressed air. DO NOT exceed the 120 PSI maximum operat- ing pressure for your model.

Before using your new nailer, set the air pressure on your regulator to the mini- mum PSI for your model.

An in-line filter/lubricator/regulator unit, depicted in Figure 2, can be installed and should be located as close to the nailer as possible.

This filter/lubricator/regulator unit will pro- tect your tool from damaging water build- up, allow you to adjust and maintain con- stant air pressure to your tool, and save you the inconvenience of manually lubri- cating your tool every time you use it.

Check the current Grizzly catalog for avail- ability of this unit. If you plan on install- ing a filter/lubricator/regulator unit in your compressed air system, always follow the connection instructions that come with the unit.

Exceeding the maximum permissible operating pressure may damage the seals, gaskets and hammer mecha- nism of your nailer. DO NOT allow your air compressor to exceed the recommended pressure when con- nected to this nailer or serious per- sonal injury may result!

Quick	Quick	Lubricator
Connector	Connector		Regulator
Your			Air
Tool			Compressor
Quick
Coupler		Quick
	Air Hose		Filter
		Coupler

Figure 2. Typical filter/lubricator/regulator installation order

-6- H7943 /H7944 Framing Nailer