5.Attach the two long brace supports to the filter braces with (4) 3⁄8"-16 x 3⁄4" hex bolts, (8) 3⁄8" flat washers, and (4) 3⁄8"-16 hex nuts, as shown in Figure 27.
Figure 27. Long brace supports attached.
6.With assistance, position the rubber mount- ing gaskets between the filter canisters and the long brace supports, and secure the can- isters with (8) 5⁄16"-18 x 3⁄4" hex bolts and (8) 5⁄16" fender washers (see Figure 28).
Mounting
Bolts
Rubber
Gaskets
Here
Figure 28. Canister filters mounted to the long
support braces.
G0637/G0638 Cyclone Dust Collector
7.Assemble the 8" x 311⁄2" flexible ducts, the noise mufflers, and the 8" x 43⁄4" flexible ducts with the 8" duct clamps (see Figure 29).
Noise
Muffler
Flexible
Ducts
Figure 29. Ducting and noise muffler connected
between blower housing and filter canister.
8.Use the 8" duct clamps to connect the duct assemblies between the outlet port of the blower housing and the canister filters.
9.Fit the plastic collection bags over the bottom of the filters and clamp in place with the metal bag clamps, as shown in Figure 30.
Bag Clamp
Figure 30. Canister filter collection bag installed.
