Grizzly Model G0638 owner manual Outlet Port and Canister Filters

6.To allow the mounting holes of the lower stand legs to align properly, slightly loosen the 16 fasteners that connect the lower stand braces to the upper stand legs (see Figure 24).

Lower Stand Brace Fasteners

Outlet Port and Canister Filters

1.Apply the 3 x 6 x 1100mm gasket to the square side of the outlet port.

2.Mount the outlet port to the blower hous- ing with (4) 5⁄16"-18 x 1" hex bolts, (8) 5⁄16" flat washers, and (4) 5⁄16"-18 hex nuts (see Figure 25).

Outlet

Port

Lower

Stand

Legs

Figure 24. Lower stand legs attached to the

upper stand assembly.

Mounting Hex Bolts

Filter

L-Braces

7.Secure the lower stand legs to the upper stand assembly with (24) 3⁄8"-16 x 3⁄4" hex bolts, (48) 3⁄8" flat washers, and (24) 3⁄8"-16 lock nuts.

8.Re-tighten the 16 fasteners connecting the lower stand braces to the assembly.

9.Remove the power lifting equipment from the assembly.

Note: The only other use for the power lift- ing equipment is moving the dust collection system into its permanent position when the assembly is complete.

-22-

Figure 25. Filter L-braces mounted to blower

housing.

3.Attach the filter L-braces to either side of the outlet port on the blower housing with (6) 5⁄16"- 18 x 1" hex bolts, (12) 5⁄16" flat washers, and

(6)5⁄16"-18 hex nuts.

4.Secure the short filter brace support to the back of the filter L-braces with (2) 3⁄8"-16 x 3⁄4" hex bolts, (4) 3⁄8" flat washers, and (2) 3⁄8"-16 hex nuts (see Figure 26).

Short

Brace

Support

Figure 26. Short filter brace support attached.

G0637/G0638 Cyclone Dust Collector