Always guard against static electrical build up by grounding all dust collection lines.
Ensure that the entire system is grounded. If using plastic blast gates to direct air flow, the grounding wire must be jumped (Figure 58) around the blast gate without interruption to the grounding system.
| Plastic | |
| Blast Gate | |
Copper |
| |
Ground | Metal Duct | |
Wire | ||
|
Figure 58. Ground jumper wire when using
plastic blast gates and metal duct.
External Ground |
|
Wire |
|
Internal |
|
Ground | Ground Screw |
Wire |
|
We also recommend wrapping the outside of all plastic ducts with bare copper wire to ground the outside of the system against static electrical build up. Wire connections at Y’s and T’s should be made with wire nuts.
Attach the bare ground wire to each stationary woodworking machine and attach to the dust collector frame with a ground screw as shown in Figure 59. Ensure that each machine is continu- ously grounded to the grounding terminal in your electric service panel.
G0637/G0638 Cyclone Dust Collector |
