Grizzly T10125 manual Recommended Tools, Inventory Figure

MODEL T10125

6" SPIRAL CUTTERHEAD

INSTRUCTIONS

The Model T10125 spiral cutterhead is designed to replace the straight knife cutterhead on the Model G0452 6" jointer.

The total procedure of changing the cutterheads and setting up the jointer takes approximately one hour. The job consists of removing the old cutterhead, installing and shimming the new spi- ral cutterhead, and readjusting the outfeed table even with the carbide inserts at TDC (top dead center). Call Technical Support at (570) 546-9663 if you need help.

TheT10125spiralcutterheadisonlydesigned to be used with the Grizzly Model G0452 6" Jointer. Do NOT install this cutterhead in any other jointer model or make. Doing so could result in property damage or serious personal injury.

Recommended Tools
Wrench 17mm	1
Precision Straightedge (Figure 1)	1
Feeler Gauge Set	1
Pair of Heavy Leather Gloves	1

G9644—12" Precision Straightedge H2675—16" Precision Straightedge

Is your straightedge really straight? These grade 00 heavy-duty stainless steel straightedges are manufactured to DIN874 standards for profes- sional results in set-up and inspection work.

	Figure 1. Precision straightedges.
Inventory (Figure 2)
A..	Spiral Cutterhead	1
B..	Torx Drivers T20	2
C.. Flat Head Torx Screws T20 M6-1 x 15		3
D.. Indexable Carbide Inserts 14 x 14 x 2		5
E.. Torx L-Wrenches T20 (not shown)		2

A

B

D C

Figure 2. Spiral cutterhead inventory.

Copyright © july, 2008 By Grizzly Industrial, Inc.

Warning: No portion of this manual may be reproduced in any shape Or form without the written approval of Grizzly Industrial, inc.

#BL10874 printed in CHINA