Extension Cords
We do not recommend using an extension cord with this machine. If you must use an extension cord, only use it if absolutely necessary and only on a temporary basis.
Extension cords cause voltage drop, which may damage electrical components and shorten motor life. Voltage drop increases as the extension cord size gets longer and the gauge size gets smaller (higher gauge numbers indicate smaller sizes).
Any extension cord used with this machine must contain a ground wire, match the required plug and receptacle, and meet the following require- ments:
T10499 Minimum Gauge Size | 14 AWG |
T10500 Minimum Gauge Size | 12 AWG |
Maximum Length (Shorter is Better) | 25 ft. |
Assembly
Except for the blade shear alignment wings (see Figure 5), the welder is shipped fully assembled.
Figure 5. Blade shear alignment wings.
The alignment wings keep the blade straight when cutting with the shear.
Tools Needed | Qty |
Phillips Screwdriver #2 | 1 |
Wrench or Socket 10mm | 1 |
To attach the blade shear wings: |
|
1.Remove the two Phillips head screws shown in Figure 6, and the attached hex nuts, and flat washers.
Note: Keep the spacers that separate the two plates in place.
Remove these
Screws
Figure 6. Phillips head screws to be removed.
2.Use the fasteners removed in Step 1 to attach the alignment wings in the positions shown in Figure 7.
Alignment Wings
Figure 7. Alignment wings installed.
T10499/T10500 Blade Welder |
