ENGLISH

56

INFORMATION ---------------------------------------------------------------------------------------------------------------------
Displaying signal information
(for digital channels only)
1 Open the menu with »i«.
2 Select the line »SOURCE SETUP« with »
V
«
or »
Λ
« and press »●« to confirm.
3 Select the line »Signal Information« with
»
V
« or »
Λ
« and press »●« to confirm.
– Information on the channel, network,
modulation, symbol rate, quality and
signal strength is displayed.
Notes:
7
The signal information changes in ac cord-
ance with the current input source.
7 The signal properties are displayed in the
lower section of the menu. The further the
bars for »Quality« and »Signal Strenght«
extend to the right, the better the reception
signal.
7 The signal level not only depends on your
receiver system, but also on t he c hannel
which is currently active. Remember this
when aligning your antenna based upon
the signal level display.
4 Press »i« to close the menu.
Pre-programming the remote control for other GRUNDIG devices
7
»DVB« has been pre-programmed for op er-
ating a GRUNDIG digital receiver (remote
control level 1).
7
»DVD« has been pre-programmed for oper-
ating a GRUNDIG DVD player.
7
»AMP« has been pre-programmed for oper-
ating a GRUNDIG AV receiver.
7
The functions available depend on the model
of the device you are using. Just try it out.

Changing the pre-programming

of the remote control

1 Press and hold »M« and simultaneously
enter the three numbers of the corre sponding
code:
»1«, »2«, »3« for a GRUNDIG DVD player.
»4«, »5«, »6« for a GRUNDIG DVD recorder.
»1«, »4«, »7« for a GRUNDIG digital
receiver (remote control level 1).
»2«, »5«, »8« for a GRUNDIG digital
receiver (remote control level 2).
»3«, »6«, »9« for a GRUNDIG digital
receiver with a hard disk (PDR).