Grundig 40 VLE 8130 BG manual Searching for television channels from the cable provider manu- ally

Special settings----------------------------------------------------------------------------------------------------------

8Start the scan with »« (red).

–All channel and favourites lists will be

deleted­ and compiled anew.

Note:

7After starting the scan, a security query will appear. Press »« (green) to confirm the option »Yes«.

–The »Results« menu appears, and the scan for TV channels begins. Depending on the number of television channels received, this can easily take a few minutes.

–The scan is complete as soon as the »PRO- GRAM TABLE« appears.

Note:

7You can abort the search by pressing »MENU«.

9Press »MENU« to end the setting.

Searching for television channels from the cable provider manu- ally

1Open the menu with »MENU«.

2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.

– The »SOURCE SETUP« menu appears.

3Select the line »Source« with »V« or »Λ« and press »OK« to confirm.

Select the option »Cable« with »<«, »>«, »V« or »Λ« and press »OK« to confirm.

4Select » Digital Manual Tuning« with »V« or »Λ« and press »OK« to confirm.

– The menu appears.

5Enter the four-digit frequency with »1 ... 0« and press »OK« to confirm.

–The search starts after confirming, the channels found are displayed in the »Re- sults« menu.

6Press »MENU« to finish the setting.

­62 ENGLISH

Searching for digital terrestrial TV channels automatically

1Open the menu with »MENU«.

2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.

– The »SOURCE SETUP« menu appears.

3 Select the line »Source« with »V« or »Λ« and press »OK« to confirm.

Select the option »Air« with »<«, »>«, »V« or »Λ« and press »OK« to confirm.

Caution:

7The antenna power supply (line »Active Antenna Power«) may only be switched on if the antenna is an active indoor antenna with a signal amplifier and it is not already

supplied­ with a voltage via a mains plug (or similar supply). Otherwise you may cause a short circuit and irreparably dam- age your antenna.

4Select the »Active Antenna Power« with »V« or »Λ«. Switch on the antenna power supply for the antenna with »<« or »>« (»On«).

5Select the line »Automatic Channel Search« with »V« or »Λ« and press »OK« to con- firm.

– The menu appears.

6Select the line »Country« with »V« or »Λ« and press »OK« to confirm. In the country

selection­ menu, select the country with »<«, »>«, »V« or »Λ« and press »OK« to confirm.

7Select the line »Scan Typ« with »V« or »Λ« and set the option »DTV« with »<« or »>«.

8Start the scan with »« (red).

–All channel and favourites lists will be

deleted­ and compiled anew.

Note:

7After starting the scan, a security query will appear. Press »« (green) to confirm the option »Yes«.

–The »Reults« menu appears, and the scan for TV channels begins. Depending on the number of television channels received, this can easily take a few minutes.

–The scan is complete as soon as the