Grundig 37 VLC 9140 S manual Searching for television channels from the cable provider manu- ally

Special settings----------------------------------------------------------------------------------------------------------

8Start the scan with »« (red).

–All channel and favourites lists will be

deleted­ and compiled anew.

Note:

7After starting the scan, a security query will appear. Press »« (green) to confirm the option »Yes«.

–The »Results« menu appears, and the scan for TV channels begins. Depending on the number of television channels received, this can easily take a few minutes.

–The scan is complete as soon as the »PRO- GRAM TABLE« appears.

Note:

7You can abort the search by pressing »MENU«.

9Press »MENU« to end the setting.

Searching for television channels from the cable provider manu- ally

1Open the menu with »MENU«.

2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.

– The »SOURCE SETUP« menu appears.

3Select the line »Source« with »V« or »Λ« and press »OK« to confirm.

Select the option »Cable« with »<«, »>«, »V« or »Λ« and press »OK« to confirm.

4Select » Digital Manual Tuning« with »V« or »Λ« and press »OK« to confirm.

– The menu appears.

5Enter the four-digit frequency with »1 ... 0« and press »OK« to confirm.

–The search starts after confirming, the channels found are displayed in the »Re- sults« menu.

6Press »MENU« to finish the setting.

Searching for digital terrestrial TV channels automatically

1Open the menu with »MENU«.

2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.

– The »SOURCE SETUP« menu appears.

3 Select the line »Source« with »V« or »Λ« and press »OK« to confirm.

Select the option »Air« with »<«, »>«, »V« or »Λ« and press »OK« to confirm.

Caution:

7The antenna power supply (line »Active Antenna Power«) may only be switched on if the antenna is an active indoor antenna with a signal amplifier and it is not already

supplied­ with a voltage via a mains plug (or similar supply). Otherwise you may cause a short circuit and irreparably dam- age your antenna.

4Select the »Active Antenna Power« with »V« or »Λ«. Switch on the antenna power supply for the antenna with »<« or »>« (»On«).

5Select the line »Automatic Channel Search« with »V« or »Λ« and press »OK« to con- firm.

– The menu appears.

6Select the line »Country« with »V« or »Λ« and press »OK« to confirm. In the country

selection­ menu, select the country with »<«, »>«, »V« or »Λ« and press »OK« to confirm.

7Select the line »Scan Typ« with »V« or »Λ« and set the option »DTV« with »<« or »>«.

8Start the scan with »« (red).

–All channel and favourites lists will be

deleted­ and compiled anew.

Note:

7After starting the scan, a security query will appear. Press »« (green) to confirm the option »Yes«.

–The »Reults« menu appears, and the scan for TV channels begins. Depending on the number of television channels received, this can easily take a few minutes.

–The scan is complete as soon as the

ENGLISH ­55