Special
Searching for digital television channels from a satellite manu- ally
If you know the parameters of a new television channel, you can also search for it manually. Current transponder data can be found in the teletext, in satellite TV magazines or on the Internet.
1Open the menu with »MENU«.
2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.
– The »SOURCE SETUP« menu appears.
3Select »Digital Manual Tuning « with »V« or »Λ« and press »OK« to confirm.
– The menu appears.
4Select the line required for the parameters with »V« or »Λ«.
–»Frequency (MHz)«: Enter the
frequency with »1 ... 0« .
–»Symbol Rate (kS/s)«: Enter the
–»Polarization«: Use »<« or »>« to set the polarisation to »Horizontal« or »Vertical«.
–»Network Search«: use »<« or »>« to se- lect the option »On« or »Off«.
–»Scan Mode«: Use »<« or »>« to select whether you want to search for unencrypt- ed (Unencrypted) channels only, encrypt- ed (Encrypted) channels only, or for both (Unencrypted + Encrypted).
–»Service Type«: Use »<« or »>« to select whether you want to search for television channels only (TV), radio stations only
(Radio), or both (Radio + TV).
5Start the scan with »« (red).
–The »Results« menu appears, and the scan for TV channels begins.
Note:
7You can abort the search by pressing »MENU«.
6Press »MENU« to end the setting.
LNB settings
Notes:
7The following description about the LNB settings premise a substantial expertise about the satellite systems. Ask your specialist dealer.
7Your TV supports SCR system (Satellite Channel Router). If you are using SCR satellite system, follow the steps described in »LNB Type« section.
1Open the menu with »MENU«.
2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.
– The »SOURCE SETUP« menu appears.
3Select »Antenna Settings« with »V« or »Λ« and press »OK« to confirm.
–The »ANTENNA SETTINGS« menu ap- pears.
4Select the line required for the parameters with »V« or »Λ«.
–»Satellite«: »Press OK«, select a satellite with »<«, »>«, »V« or »Λ« and press »OK« to confirm.
–»Transponder«: »Press OK«, select a tran- sponder with »<«, »>«, »V« or »Λ« and press »OK« to confirm. Use »« (red) to add a transponder, use »« (green) to delete it, or use »« (yellow) to change transponder data.
–»LNB Power«: Set the LNB power supply (depending on the type of LNB) to »Off« »13/18 V« or »14/19 V« with »<« or »>«.
–»LNB Type«: Select the LNB type used in the satellite system with »<« or »>«. If you are using a satellite antenna with an Single Cable Distribution multiswitch, select the setting »Grundig SCR«. After it, please perform the »User Band«, »KB Frequency« and »LNB Selection« settings in the submenus. The necessary parameters you will get from the operator of the satellite antenna. Use only this specification!
»User Band«: Select the user band number assigned to the user with »<« or »>«.
