MEMORY FUNCTIONS
MEMORY DESCRIPTION
The SATELLIT 800 MILLENNIUM contains 70 memory locations that can be used to store and recall commonly monitored frequencies. These 70 locations are divided into blocks of 10, ie.
(I)Frequency, (2) Mode, (3) Bandwidth, (4) AGC setting,
(5) Attenuator, (6) Synchronous detector.
STORING A MEMORY CHANNEL
First, be sure that the SATELLIT 800 MILLENNIUM is in the VFO mode (MEMORY or SCAN not displayed). If
required, press the 
button to place unit in the VFO mode.
(A)Select the desired frequency, mode, bandwidth, etc.
(B)Press the 
button. 'MEMORY' will light and the memory channel number will flash for approximately 3 seconds. While it is still flashing, enter a
RECALLING A MEMORY LOCATION
To select a specific memory channel, press the 
button. This will cause 'MEMORY' to light on the front panel display, and the MEMORY channel number will flash for approximately 3 seconds. While it is still flashing, enter a two digit number of the desired memory channel to be received. Make certain that the successive button depressions are made within 3 seconds of each other. Other
memory channels may be selected by pressing the 
button and entering two digit
numbers. If a channel number is selected that is empty, 'Error' will flash.
The large 'TUNING' knob may be used to tune from the frequency that was stored in the selected memory channel. The 'MEMORY' symbol turns off, but the last memory channel
number still shows. Pressing the
button will cause the receiver to return to the last selected memory channel number and the 'MEMORY' symbol will turn on.
DELETING A MEMORY LOCATION
Select the memory channel to be deleted as described in 'RECALLING A MEMORY LOCATION'. Press and hold the
button for 3 seconds. A beep will be heard to indicate that the contents stored in the selected memory channel number have been deleted.
19
