Grundig DR 5400 DD manual Rectifying minor problems, English, Information

INFORMATION ___________________________________

Rectifying minor problems

Not every picture or sound problem is caused by a defect in your DVD receiver. Defects can also be caused by leads having been accidentally pulled out, damaged discs and worn out batteries in the remote control. If the following measures do not rectify the problem, consult your authorised dealer.

Due to the difference in quality of the recording media and the quality of the recording itself, it can occasionally happen that a home-made disc cannot be read. This does not indicate a malfunction of the DVD receiver.

Fault	Possible cause/remedy
The DVD receiver will not switch on.	No electrical supply:
	Check the connection to the mains cable.
The DVD receiver does not respond to	Obstacles, used batteries:
the remote control.	Remove all obstacles which could disturb the signal of the
	remote control.
	Test or replace the batteries of the remote control.
No picture or sound.	Incorrect cable connection, the video or audio connection
	cable is faulty:
	Check the connections on the DVD player and on the
	television.
	The MUTE function has been activated:
	Deactivate this function as described on page 28.
No sound from some loudspeakers,	Activate the test tone (see page 21). If you hear a signal
e.g. centre, surround or subwoofer.	from all the loudspeakers, then the loudspeaker setting
	and cabling are correct. In this case the multi-channel
	mode is set incorrectly or the inserted disc does not
	produce multi-channel sound.
	Check the multi-channel settings on the DVD receiver.
	Check the loud speaker settings in the set-up menu.
No sound or insufficient bass tone	The subwoofer has been connected incorrectly:
coming from the subwoofer.	Check to make sure the subwoofer has been connected
	properly.
The inserted disc does not play.	Make sure the printed side of the disc is facing upwards.
	Clean the disc. The DVD receiver cannot read the
	inserted disc format. Check to see if the inserted DVD
	has the regional code 2.
	The parental lock settings prevent the playback of the
	disc: Alter the parental lock settings (see page 24).
Search, slow motion, playback repeat,	The relevant functions are not available with the inserted
programmed playback etc. do not	disc.
work.
Insufficient MP3 playback or none at	The sampling frequency 44.1 kHz has not been observed.
all.	Burn a new MP3 CD observing the sampling frequency.
CD-Rs or CD-RWs are not played	Faulty software or hardware settings during burning or
back, or are played back incorrectly.	the CD itself.
	Check the components of your CD burner/software or
	change the CD being used.
Distorted audio signal during FM	Poor stereo reception.
reception.	Correct the frequency manually, if necessary.
	Faulty antenna connection.
	Check the antenna connection.
You have forgotten the personal access	Enter the master code »8888«.
code for the parental lock.

ENGLISH

47