
SETTINGS____________________________________________________________________________
24HOUR
12HOUR
14:39
10:39
10:23
Setting the time
When the DVD Micro System is connected to the mains for the first time, a demo program runs in the display. This can be interrupted with » DEMO/OK«. After- wards the clock flashes to indicate that it needs to be set. The following settings may only be performed in standby mode. During the setting, if no button is pushed for more than 10 seconds, the DVD Micro system ends the procedure automatically. You then have to start again.
1To set the 24 hour format press » PROGRAM« and hold it down.
–Display: »24 HouR«, »24« flashes.
2To set the 12 hour format, press » TUNING 3« or » TUNING 4«.
–Display: »12 HOUR«, »12« flashes.
3To set the clock press » PROGRAM« again.
–Display: the hours flash.
4Set the hours with » TUNING 3« or » TUNING 4« and confirm with » PROGRAM«.
–Display: the minutes flash.
5Set the minutes with » TUNING 3« or » TUNING 4« and confirm with » PROGRAM«.
–Display: the current time.
Notes:
You must reset the time after a power failure or when the mains plug is pulled out.
Some RDS stations transmit an RDS time signal. If RDS time synchronisation is activated on the DVD Micro System (»SYNC ON«) (see page 38), the time is automatically updated when this new information is received.
Time synchronisation can take several minutes, and even with good reception the accuracy depends on the time signal being transmitted. The automatic setting is always activated when the DVD Micro System is switched from standby to tuner mode and receives a suitable RDS station.
General information
You can make the settings required for operating the system in the
To do this, switch on the television and switch it to the channel on which the DVD Micro System is set. You can only make settings with the remote control in disc mode when the device is stopped.
1 Switch on the DVD Micro System from standby by pressing »DVD II« on the device or »DISC/RANDOM« on the remote control.
20