ADDITIONAL INFORMATION continued
OPERATES ERRATICALLY
Perform a RESET, as described in the section titled RESET PROCEDURE.
STATIONS ARE RECEIVED TOO WEAK
•Assure that the DX/LOCAL switch is set to the DX position
•Assure that the telescopic antenna is pulled up all the way for FM and Shortwave reception
•If listening to AM stations, swivel the radio. The internal ferrite bar AM antenna is highly directional
THERE IS NO SOUND FROM THE SPEAKER
Assure that earphones/headphones are not plugged in and that the volume control is turned up.
A STATION CAUSES SEVERE AUDIO
DISTORTION, BUT SEEMS TO BE VERY STRONG IN SIGNAL STRENGTH
This is probably a strong, local station, very close to your location. Because of its close proximity to you, its signal is too strong. To reduce signal strengths, place the DX/LOCAL switch into the LOCAL position. Also, try retuning the station with the FINE TUNING control.
YB 550PE OPERATION MANUAL
ADDITIONAL INFORMATION continued
THE BATTERY COMPARTMENT A STICKY LIQUID OR DRIED WHITE POWDER IN IT
This is the result of battery acid leakage. Battery acid leakage is not covered by warranty. Do not throw away the leaked batteries and immediately contact their manufacturer.
RESET PROCEDURE
When performing a ‘reset’, assure that the batteries in use are good. If the radio does not function and the solutions below do not resolve the problem, perform a ‘reset’. To do this, remove the batteries and press/release the small, round button recessed into the battery compartment floor, using a straightened out paper clip or ballpoint pen. Reinstall the bat- teries and test the radio. If it still does not resolve the prob- lem, try again, pressing the button two or three times.
46 | 47 |
