GSI Outdoors PNEG-214 installation manual Flashing Support Stiffeners, A

12. Flashing Support Stiffeners

Stiffener Flashing Support Instructions for Internal Universal Stiffeners

1.Install the floor and support system, cutting the floor to go around the internal stiffeners as required.

2.Break the stiffener flashing support (SS-6984) into its three (3) components.

3.Lay the flashing supports on top of the flooring and weld the flashing supports to the stiffener as close as possible. Fasten the flashing to the wall, flashing support, and floor. Seal all spaces by welding or caulking.

4.Paint all welds with good quality zinc rich paint.

5.Stiffener flashing supports (SS-6984) must be ordered separately from the standard floor and flashing.

Figure 12A

PNEG-21412'-18 Cor-Lok and Cut-Lok Flooring

29