GTO GP-SW050 Connecting the Gate Arm to the Gate, Install the key into the output shaft. Fig

Connecting the Gate Arm to the Gate

Key

Output Shaft

Fig. 1

Bolts	Reducer
and	Arm
Washers

Fig. 2

1.Install the key into the output shaft. (Fig. 1)

2.Fit the end of the reducer arm onto the output shaft as shown and tighten the bolts. (Fig. 2)

3.Turn the power on.

4.Set DIP switch 1 to designate the operator arm as left or right (Fig. 3)

(right is shown here).

5.Manually move gate to the closed position. (Fig. 4)

OFF			ON
OFF		ON	ON
<<<	1		>>>
DELAY	2		SIMUL
MASTER	3 4		SLAVE
SAFE			SECURE

Fig. 3

OPTIONS

MODE 1

MODE 2

OPEN DIR.

SLV OPN DUAL MODE LOW BATT

Gate Bracket

	Closed Gate
	(approx)	Operator Arm
		Reducer Arm
Clevis Pin	5°-10° Angle
	Fig. 4
Hairpin Clip		Closing	CAUTION:
Fig. 5			DO NOT STAND
			IN THIS AREA

6.Unfold the arm to approximately a 5-10° angle. (Fig. 4)

7.Use ‘CLOSE’ button on control board to move operator arm/reducer arm to the gate. CAUTION: Be careful not to stand in the gray area surrounding the operator. (Fig. 4) Be prepared to stop (using the ‘STOP’ button) when the gate arm and reducer arm near the desired position.

NOTE: Use ‘JOG’ buttons to fine tune the position.

8.Mark the position of the gate bracket holes on the gate, drill holes and mount bracket.

9.Fit the end of the operator arm into the gate bracket and attach using clevis pin and hairpin clip. (Fig. 5)

Fig. 6	NOTE: Gate Arm’s length can be adjusted
	by rotating the gate arm’s tube before
	mounting it to the gate bracket. (Fig. 5)

15