GTO owner manual TroubleShooting Guide, GP-SW050 Audible Feedback

TroubleShooting Guide

WARNING: ALWAYS TURN OPERATOR OFF AND DISCONNECT

BATTERIES BEFORE ADJUSTING OR SERVICING IT.

GP-SW050 Audible Feedback

S y m p t o m	D i a g n o s i s	C h e c k
One beep every 5 seconds	There is no AC power present.	•	GFI
when the gate is in motion.		•	Circuit Breaker
		• Connections in the Field Wiring
			Connection Compartment
	The battery voltage is low.	•	Battery Connections
		•	Battery Voltage
		•	Load Test Battery
One beep every 10 seconds	The battery is critically low.	•	GFI
when the gate is idle.		•	Circuit Breaker
	If #4 dip switch is in the FAIL SAFE	•	Connections in the Field Wiring
	position and the gate is at the OPEN		Connection Compartment
	Limit, the operator will be disabled until	•	Battery Connections
	AC power is restored and the battery	•	Battery Voltage
	voltage has reached 26 vdc.	•	Load Test Battery
	If #4 dip switch is in the FAIL SECURE
	position and the gate at the CLOSED
	Limit, the operator will be disabled until
	AC power is restored and the battery
	voltage has reached 26 vdc.
1 beep with 2 seconds	The revolution counter circuit board is	•	Check Connections for Limit
pause	not being detected.		Sensors on Logic Board
2 beeps with 2 seconds	The logic board does not detect the	•	Check BLDC Speed Control
pause	motor drive board connections.		connections on Logic Board and
			Motor Drive Board
3 beeps with 2 seconds	The gate has traveled outside the	•	Check Limit Sensor Connections
pause	maximum allowable limit of the		on Logic Board
	operator.
4 beeps with 2 seconds	The motor has moved in the wrong	•	Check BLDC Speed Control
pause	direction.		connections on Logic Board and
			Motor Drive Board

5 beeps with 2 seconds	No movement was detected from the	•	Check path of Gate for
pause	motor twice.		obstructions.
		•	Check to ensure motor is not
			jammed.

30