ACT1000/2000 Operating Instructions | Software Version |
Display Log
The Display Log function allows the operator to view events in the historical log directly on the LCD display. When this option is selected, the latest event in the log is displayed with the time and date on the top line of the display, and the event details being scrolled across the bottom line. Each log event will be displayed in turn (stepping backwards in time) until the end of the log is reached. Pressing the 0 key advances immediately to the previous event without waiting for it to be displayed. Pressing the ✔ key locks the current event on the display until ✔ is pressed again. Pressing the ✘ key exits from the display log function.
Print Log
The Print Log function allows the user to request the immediate printing of the entire system log on an attached serial printer. If
ACT Recommend the Epson |
|
Wiring between Printer & Controller: Controller | Printer |
0v TX RX | SERIAL (25 way connector) |
PIN 7 | |
PIN 3 | |
PIN 20 |
Printer settings:
CHARACTER TABLE PC850
PAGE LENGTH OF TRACTOR 11 INCHES
SKIP OVER PERFORATION OFF
AUTO TEAR OFF OFF
GRAPHIC PRINT DIRECTION
SOFTWARE ESC/P2
AGM OFF
AUTO LINE FEED OFF
INTERFACE SERIAL
BIT RATE 9600BPS
PARITY BIT NONE
DATA LENGTH 8 BITS
EXT/ACK OFF
STATE REPLY OFF
Filter Log (ACT 2000 Only)
The Filter Log function allows the user to prevent certain events from being entered on the system log. Normally all events are logged, but to prevent ACTWinPro from having to store a lot of information on a large installation, some events may be filtered out.
The event types that can be filtered are access granted, access denied, alarms (mains fail, tamper etc.), door events (exit button pressed etc.) and others. The 0 key advances to each event type, and the ✔ key enables or disables the displayed event type.
The events may also be filtered out on certain doors. Normally all doors are allowed, but the user may prevent certain doors from reporting events.
Page 7 of 32