Changing the Channel the Keyboard is Using
When two devices are being used in the same proximity, each device should be set to operate on a unique channel. For the best reception, space the channels apart by one or more chan- nels. For example, setting the channels to “2” and “4” is rec- ommended over setting the channels to “2” and “3”.
If you are installing three or more devices on a single receiver, see “Installing 3 or More Devices” on page 9. Remember if a Teach/Learn sequence has already been performed, it is not necessary to
To change the channel:
1.Press and hold the Channel button on the back of the keyboard for two seconds.
2.When you release the Channel button, the keyboard will change to the next sequential channel and the green LED light on the front (or the back) of the keyboard will flash. The number of flashes indicates the new channel the key- board is using.
Powering the Keyboard On and Off
It is not necessary to power down the keyboard when it is idle. However, it is recommended you power down when traveling to avoid inadvertent key presses that may occur.
To power on:
Simultaneously press and release the Channel and Teach buttons on the back of the keyboard for three seconds. It will confirm it is powering on by flashing its LED light for one second.
To power off:
Simultaneously press and release the Channel and Teach buttons on the back of the keyboard. It will immediately power off and be unresponsive to button clicks. It will confirm it is powering off by flashing its LED light three times.
4
