AUDIO GROUND CHASSIS/FLOAT SWITCH
In general, the Audio Ground of each amplifier should be connected to AC mains earth ground AT ONE POINT ONLY- either through the Chassis (by selecting the "Chassis" position) OR through the input cable (with the switch in the "Float" position, and pin 1 of the XLR or the sleeve of the 1/4" connected to the ground of the signal source unit.)
The Chassis/Float switch can be used as a means to troubleshoot ground loop problems, or to verify wiring. Ground loops are characterized by a hum or buzz through the speakers, and occur when multiple paths exist for a given ground circuit. This switch allows the Audio Ground to be temporarily "lifted" or "floated" from the chassis, so continuity tests can be made to verify or
•The chassis is permanently conected to the earth (safety) ground pin of the Mains power connector.
•The Audio Ground of each SR2300/SR2800 is permanently connected to the black terminals of both output binding posts, to pin 1 of each XLR input, and to the sleeve of each 1/4" input.
•The XLR shell is permanently connected to chassis.
•With the Chassis/Float switch in the "Chassis" position, the Audio Ground will be connected to the Chassis and AC mains earth ground. This connection is made through a 0Ω resistor (R350) located on the input board. The resistor serves as a
fuselink in the case of severe system faults. To check this resistor, remove all connectors from the amplifier and discon- nect the AC main plug. With the switch in the "Chassis" position, use an ohmmeter to measure the 0Ω resistance between the earth ground pin of the AC mains plug and Audio Ground at either black terminal of the output binding posts.
•By selecting the “Float” position, the Audio Ground is not directly connected to the chassis, and can be referenced to
some other ground through the input cable or speaker ground. For safety reasons, a 0.1uF capacitor (C125) permanently connects Audio Ground to chassis at RF frequencies, but only presents 27kΩ of impedance at 60Hz.
!OUTPUT
The speaker output connectors are dual binding posts which will accept wire up to 12 AWG, or spade connectors. They are spaced on 3/4" centers for use with dual banana plugs. The positive output red terminals are oriented such that a dual banana plug can be used for bridged mono operation.
POWER SWITCH
The power switch is located on the front of the amplifier. Two green "Power" LEDs indicate that the corresponding amplifier channel is turned on. Standard practice is to turn the amplifier on last, and off first when powering your system on and off. This insures that any turn on/off glitches in source components or signal processing equipment will occur before the ampli- fier is turned on, or after it is turned off. It is possible to leave the power switch on at all times and switch the amplifier remotely with a breaker switch or other AC power switch. When doing so make sure the switch is rated for the current required by the amplifier.
!THX (SR2800)
The SR2800 is THX approved only when installed and adjusted by an authorized service technician and the security cover is installed to prevent further adjustments.
Install the plexiglass security cover onto the front of the amplifier with the screws provided. Ensure the access hole for the power switch is located properly.
NOTE: To maintain THX approval, when the system requires service, adjustment or reconfiguration, have it done by an authorized service technition.
– 13 –
