Hafler SR2300CE, SR2800CE owner manual Bridge Mono Mode SR2300/SR2800, 70V Mono Mode SR2300/SR2800

BRIDGE MONO MODE (SR2300/SR2800)

CE SPEAKON

Connector

Wiring

Connect to CH A output

1.Connect signal from source to CH B input.

2.Biamp/Stereo switch not active-(Stereo/Mono switch overrides this switch when in mono/70V/100V mode).

3.Move Stereo/Mono switch to MONO mode.

4.Set load switches (8Ω/4Ω/2Ω) to 1/2 the actual load impedance. (16Ω/8Ω/4Ω) i.e. for a 4Ω speaker load, select the 2Ω setting for both CH A and CH B Load Switches

70V MONO MODE (SR2300/SR2800)

5.Connect appropriate speaker load 16Ω/8Ω/4Ω across the red terminals of the 5-way binding posts. CE units: Wire SPEAKON as shown above and connect to CH A output.

6.CH B level control adjusts the mono output level. (1400W-SR2800, 700W-SR2300)

CE SPEAKON

Connector

Wiring

Connect to CH A output

1.Connect signal from source to CH B input.

2.Biamp/Stereo switch not active (Stereo/Mono switch overrides this switch when in mono/70V/100V mode).

3.Move Stereo/Mono switch to 70V mode.

4.Select 70V load, both channels.

5.Connect parallel array of 70V transformer-equipped speakers across the red terminals of the 5-way binding posts. (1400W–SR2800, 700W–SR2300) CE units: Wire SPEAKON as shown above and connect to CH A output.

6.CH B input sensitivity controls 70V mono output level. Amplifier will clip at 70Vrms level.

– 19 –