Hafler 100V MONO MODE SR2300/SR2800, 70V STEREO MODE SR2800 ONLY, CE SPEAKON Connector

100V MONO MODE (SR2300/SR2800)

Load Power

100V 70V

8Ω 4Ω 2Ω

100V 70V

8Ω 4Ω 2Ω

CE SPEAKON Connector

100V 70V

SR2300

CH A	BIAMP STEREO	CH A
IN		OUT
CH B		CH B
IN	(Mono)	OUT

100V 70V

			SR2800
	– 3		–
	–	+
	+		300W
1	2		2Ω – 8Ω
	Audio GND
	Chassis Float
	600W	–	+
	4Ω– 16Ω	+
	Mono,70V,100V		+
For 70V, 100V, or Mono
• Use CH B input
• Load across RED
terminals
• Set load switches to one			300W
half load impedance			2Ω 8Ω
			–

S R 2 3 0 0

300 W Stereo, 2Ω – 8Ω

600W Mono, 70V,100V

Attention: Utiliser un fusible de rechange de même type.

CAUTION: For continued protection from risk of fire, replace only with same type and rating of fuse.

250W 250V T7A 100V-120V~

50-60Hz

A Division of

Rockford Corp.

Tempe, AZ 85281

Made in the U.S.A.

Wiring

Connect to CH A output

100 Volt	100 Volt
Transformer	Transformer

Parallel Array

etc.

1.Connect signal from source to CH B input.

2.Biamp/Stereo switch not active (Stereo/Mono switch overrides this switch when in mono/70V/100V mode).

3.Move Stereo/Mono switch to 100V mode.

4.Select 100V load, both channels.

5.Connect parallel array of 100V transformer-equipped speakers across the red terminals of the 5-way binding posts. (1400W – SR2800, 700W – SR2300) CE units: Wire SPEAKON as shown above and connect to CH A output.

6.CH B input sensitivity controls 100V mono output level. Amplifier will clip at 100Vrms level.

70V STEREO MODE (SR2800 ONLY)

CE SPEAKON

Connector

Wiring

1.Connect signal from source to both CH A and CH B inputs.

2.Move Biamp/Stereo switch to Stereo mode.

3.Move Stereo/Mono switch to Stereo mode.

4.Select 8Ω speaker load for each channel.

5.Connect parallel array of 70V transformer-equipped speakers (up to 700W per channel) to 5-way binding posts. CE units: Connect as shown above for Dual SPEAKONs or Single 4-Wire SPEAKON.

6.Adjust CH A and CH B level controls independently.

– 20 –