Safety precautions
Please insertthe power cord into special rece-
ptacle with rated voltage.Ifthe power cord is
three-phase wire,please use three-phase rec-
eptacle.The earthing terminalof the receptacle
mustbe earthed reliably.If it is two-phase wire,
please guarantee thatthe earthing wire is ear-
thed reliably.Ifpossible ,please adopt electric
leakage protector.
Do notdamage the power cord,bend ,extend,twist,bind or alter it by force.Do not press or
nip itwith weight.If the powercord or the power plug is bad, or the power plug becomes
flexible,to avoid risk itis required to have it replaced by the technicians of our special
shop or the costomercare agent. Keep the pin of the power plug clean,if the
powerplug is polluted with dust,please wipe with dry cloth carefully.
The powercord plug should be convenient
to be pluged in orpluged out with hand
while the washing machine runs normally.
Be sure to pull the plug outand close the
watertap when the machine is idle,when
moving the machine,or when cleaning
the machine.Do notuse wet hand to ins-
ert orpull out the power plug.
In case the washing machine isinstalled
on ground withcarpet, do not block the
ventilation hole with carpet.
Do not let the machine share one receptacle
with other electricappliances. If the power
plug is damaged,or the plugging into the
receptacle is loose, do not use the plug any
more.
Do not wash water-proof laundries like
the raincoat, bike covers etc. to avoid
abnormal vibrations.
Do not use water hotterabove 50 C .
Do not put the machine at damp place like
the bathroom. Never wash it with water.
Not put wet laundries on the control panel.
softitems
Theventilation holes
atthe bottom
1.After washing,close the water faucet. (If needed,you can dismantle the water inlet hose).
5.Wipe off the water drops on the surface ofthe machine and inside the tub. Open the top lid for some time (
about1 hour), then close the top lid.
4.Hang up the power cord and drain hose.
3.Be sure to pull off the power plug before maintenance.
2.Do notstore water in the washing machine for a long period. Drain thewater completely after each using.
The filter screen ofthe water inlet valve is likely to be
blocked by foreign materials and influence the water
inlet.
Please clean itwith brush every two months.
If the cabinetis dirty, wipe it with wet cloth
Do notflush it directly with water.
Wipe itwith neutral detergent.
Do notwipe it with thinner, petrol, alcohol etc.
After using,please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence
your using the machine.
Disposal after washing
Please firstpull off the power plug from the receptacle before cleaning.
215
Figure 2
The back cover of lint filter
Install
Dismantle
Down
Up
Figure 1
Down
Dismantle
Install
Up
The front coverof lint filter
Lint filter:
The lint filter must be used during washing.
It must be cleaned in time after each using.
1.Push down thespring piece of thetop lint filter to
make theclaws out of the filter cover, and then
pull out the lint filter toget it down. figure1
2.Pull theback of thelint filter, and then youcan get
downit off the front cover of thelint filter. figure2
3.Sweep therubbish in thelint filter.
4.Put theback of thelint filter into the front cover .
5.Put thelint filter intofilter cover, and make it tight .
6.Make sure thelint filter wellinstalled, or it can
influence your use.