Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.
Install the inner cover
1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover, aiming the inner cover shaft to the installation hole of the corresponding outer tub cover shaft groove. 3.Firstly insert the inner cover shaft of one side into the corresponding outer tub
cover shaft groove, then push the another inner cover shaft into the corresponding outer tub cover shaft groove. Please install to designated position to guarantee there are no dropping or abnormal sound in opening and closing of the inner cover, and the operation shall be smooth. Do not dismount the inner cover component after washing.
Outer tub cover
Outer tub cover shaft groove | Right hand |
| |
Inner cover shaft | Left hand |
Inner cover component |
|
After switching on the power, the washing machine will set to common program including"wash, rinse,
spin "automatically.To select other procedures, push the " WASH"," RINSE"or "SPIN"button to select the
time of wash and spin, and the times of rinse. After switching on the power,if you push one of the button among "RINSE"and"SPIN the digitron of the former procedures will turn off automatically. The former procedures will not run. For instance: after switchingon the power. If you push the "SPIN" button first, it will execute spin singly after starting.
Attention
Even there's no water in the tub, a certain period is required before spin starting.
Separate the laundries that are not colorfast from other laundries in washing.
Do not use the HEAVY program for the woollen textiles. The pulsator will not rotate unless the water is
filled to water level .
Figure 1
Figure 2
After the machine starts operation, you can set the program and procedure during washing, set spinning time during rinsing but can not make setting in other cases.
Install the bottom plate
After you open the package, please lean the washing machine gently down on softitems ( like the towel cloth, blanket, etc. ). Install the bottom plate to the bottom of
the machine with the eight screws by a cross screwdriver, then lift the machine up gently. See to the figure:
Bottom plate
Back
Front
Screw soft items
Press " WATER LEVEL "button, |
|
select suitable water level | WATER LEVEL |
After switching on the power, select a suitable water level to detect the cloth. To select other water level.Refer 
Adjust the installation position
The washing machine shall be more than 20mm away from the wall.The largest allowed slope of the supporting base of the machine is 2
. The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods:
to "water level, water quantity and desoge of powder"in Page 9 and "WATER LEVEL/DISINFECT"button in Page 10 for the selection.
Page 9 | Page 10 |
Confirm it's horizontal:
Hang the lead line to confirm if it is horizontal.
Adjust the adjustable foot:
1.To twist the adjustable foot, please first lift up the side of the foot slightly, loosen the adjustable nut, and twist the foot.
2.Fasten the nut after adjustment.
adjustable nut
Loosen 
Fasten
High Low adjustable foot
4
13
