b Steps of using the operation buttons and description of the steps
How to change the direction of the drain hose
| POWER |
| ON/OFF |
MIN | START |
PAUSE |
1.Lean the machine down gently with the front surface facing the ground. Loosen the eight screws by a cross screwdriver.
Back | Bottom plate |
| |
Front |
|
| Soft item |
3.Extend the drain hose from the left side. Push the drain hose into the groove with hands.
Push the drain hose into the groove with
1 Push the POWER ON/OFF button to |
|
switch on the power | ON/OFF |
| POWER |
After switching on the power,DISINFECT is not selected |
|
To select DISINFECT,push WATER LEVEL/DISINFECT | over 2 seconds, |
the DISINFECT function works,then push 2 or 3 to select a suitable program.
2 Push the PROGRAM SELECTION button to select the suitable automatic program
PROGRAM
After switching on the power, the machine will set to STANDARD program automatically. To select other program, push the PROGRAM SELECTION button till the corresponding indicator is on. Refer to the PROGRAM SELECTION button in Page 11.
For example: select SAVE wash for the quick washing of
the laundries with light dirt. | Page11 |
| |
|
|
3 Push WASH
RINSE
SPIN button to select suitable programs
MIN
2.Pull out the drain hose from the groove at the right side.
Use groove at |
|
|
|
|
|
| 4.Install the bottom plate (as per indicated before), | |
|
|
|
|
| ||||
| ||||||||
this side after |
|
|
|
|
| then lift the machine up gently. | ||
direction changing |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Using the drain hose
The drainage shall be smooth with the drain hose.
1.put the drain hose up to suitable position (Do not 2.Do not step on or press the drain hose. put it on ground.)
Notes: The highest point of drain pipe shuold be higher than the water level of washing tub for avoiding to siphon phenomenon during drain.
0.7m<H<1.2m
12 | 5 |
