Installation Procedures
1. DRILLING FOR PIPING
Select piping and drain directions. (Fig.11)
Rear (Install the drain hose in the direction.)
Right
Fig. 11
CAUTION
Install the drain hose at the rear; it should not be installed on the top or right side.
When the directions are selected, drill 80mm and 50mm or 150mm dia. hole on the wall so that the hole is tilted downward toward the outdoor for smooth water flow.
Fig. 12 | Wall |
| |
| 6mm |
2.DRILLING HOLES FOR ANCHOR BOLTS AND INSTALLING THE ANCHOR BOLTS
With a concrete drill, drill four 12.7 mm dia. Holes. (Fig.13)
Fig. 13
60 to 70mm
12.7mm
Insert the anchor bolts into the drilled holes, and drive the pins completely into the anchor bolts with a hammer. (Fig. 14)
3. INSTALLING BRACKETS
Install the brackets with nuts, washers and spring washers.(Fig. 15)
Fig. 15
Spring washer |
|
Special nut | Bracket |
|
Bracket (Left) | Bracket (Right) |
4. INSTALLING INDOOR UNIT Reset the hex bolts as shown in Fig.16.
Fig. 16
Hex bolt
Indoor unit 
8 to 13mm
Apply the indoor unit to the brackets.(Fig.17)
Fig. 17
Bolt Bracket
Indoor unit
Now, securely tighten the hex bolts in both sides.
Fig. 14 | 11 |
