Installation Procedures
HOW TO CONNECT WIRING TO THE TERMINALS
A.For solid core wiring (or F-cable)(Fig.24A)
(1)Cut the wire with a wire cutter or
(2)Using a screwdriver, remove the terminal screw(s) on the terminal board.
(3)Using pliers, bend the solid wire to form a loop suitable for the terminal screw.
(4)Shape the loop wire properly, place it on the terminal board and tighten securely with the terminal screw using a screw driver.
B.For strand wiring(Fig.24B)
(1)Cut the wire with a wire cutter or
(2)Using a screwdriver, remove the terminal screw(s)on the terminal board.
(3)Using a round terminal fastener or pliers, securely clamp a round terminal to each stripped wire end.
(4)Position the round terminal wire, and replace and tighten the terminal screw using a screw driver.
Fig. 24 | 25mmStrip | A. Solid wire |
| Loop | |
|
|
Insulation
B. Strand wire
Strip 10mm
Round 
terminal
Wire
Screw with special washer
Round
terminal
Terminal
board
Wire
Screw with special washer
Round terminal
HOW TO FIXED CONNECTION CORD AND POWER CABLE AT THE CORD CLAMP
After passing the connection cord and power cable through the insulation tube, fasten it with the cord clamp, as shown in Fig.25
Fig. 25 | Insulation tube |
Cord clamp
Use
13
