Haier AS092XVERA, AS182XVERA, AS072XVERA, AS122XVERA installation manual Operation, Clock set

Operation

Clock set

When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows: Press CLOCK button, "AM"or "PM" flashes.

Press or to set correct time. Each press will increase or decrease 1 min . If the button is kept pressed, time will change quickly.

After time setting is confirmed, press SET, "AM" and "PM" stop flashing, while clock starts working.

MODE	HEALTH AIRFLOW
SLEEP	FRESH	SWING
CLOCK		SET
1 TIMER	2	STERILIZE3
RESET	CODE LIGHT	LOCK

Remote controller's operation

When in use, put the signal transmission head directly to the receiver hole on the indoor unit

The distance between the signal transmission head and the receiver hole should be within 7m without any obsacles as well.

Don't throw the controller, prevent it from being damaged.

When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wireless telephone is installed in the room, the receiver is apt to be disturbed in receiving the signal so the distance to the indoor unit should be shorter.

Loading of the battery

Slightly press " " and push down the cover. Load the batteries as illustrated.

2 R-03 dry batteries, (cylinder)

Be sure that the loading is in line with the "+"/"-" pole request as illustrated.

Put on the cover again.

Confirmation indicator:

In disorderation, reload the batteries or load the new batteries after 5 mins.

Note:The waster batteries should be disposed properly,use two new same-type batteries when loading.

If the remote controller canít function normally or doesnít work at all,use a sharp-pointed item to press the reset key.

2R-03 dry batteries

Hint:Remove the batteries in case unit wonít be in usage for a long period. If there are any displays after taking-out just need to press reset key.

When throw away the waste batteries, please perform in accordance with the local regulation.

8