English
Installing Your Beverage Center
Unpacking Your Beverage Center
1.Remove all packaging material. This includes the foam base and all adhesive tape holding the beverage center accessories inside and outside.
2.Inspect and remove any remains of packing, tape or printed materials before powering on the beverage center.
Leveling Your Beverage Center
•Your beverage center has four leveling legs whch are located in the front and rear corners. After properly placing your beverage center in its finals position, you can level it.
•Leveling legs can be adjusted by turning them clockwise to raise your beverage center or by turning them counterclockwise to lower your beverage center. The beverage center door will close easier when the leveling legs are extended.
Note: If your beverage center has been titlted for any reason, wait 24 hours before plugging it in.
Install Limitations
•Do not install your beverage center in any location not properly insulated or heated e.g. garage etc. Your beverage center was not designed to operate in temperature settings below 55˚ Fahrenheit.
•Select a suitable location for the beverage center on a hard, even surface away from direct sunlight or heat source e.g. radiotors, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected with the leveling legs located on the front and rear botto m corners of the beverage center.
•
Note: Remove the upper hinge cover before
4