Installation | EN |
Positioning the appliance
Positioning the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dish- washer is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation.
Levelling the appliance
Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the dishwasher, making it level. In any case, the appliance should not be inclined more than 2˚. If the appliance is level, it will help ensure proper performance.
Cold water connection
Connect the water supply hose to a water outlet tap, making sure that it is fastened tightly in place (see fig.A). Make sure the rubber washer is seated firmly in the bottom of the connector.
If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inletcan get blocked and damage the appliance.
fig.A
Warning
The appliance is to be connected to the water mains using new
Drain hose connection
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to avoid bending or crimping it. If necessary, fit a syphon trap
fig.B
Attention:
The connecting piece for syphon trap
Electrical Connection
After making sure that the voltage and frequency values for your home corre- spond to those on the rating plate (located on the stainless steel inner door of the appliance) and that the electrical system is correct for the maximum voltage on the rating plate, insert the plug into an electrical socket which is earthed properly (the earthing of the appliance is a safety requirement mandated by law).
If the electrical socket to which the appliance must be connected is not appro- priate for the plug, replace the whole cable, rather than using adaptors or the like as they could cause overheating and burns.
Anti-Flooding protection (for some models)
Your dishwasher has an overfill protection device which could automatically shut off the inlet valve and starts the drain pump if the water level in the unit is detected to be above the normal level.
If this occurs, turn off the main water supply before calling for servicing. If there is water in the base pan because of an overfill or small leak, the water should be removed before restarting the dishwasher.
Caution:
The dishwasher plug must be accessible even when the appliance is installed as a
2
