17
After 3 seconds the delayed start indicator “ E ” blinks, the time-remaining indicator “ G ” will blink and
decrease , the programme will start until the delayed st ar t indic ator “ G ” goes out .
3in1 function
When using "3 in 1"combination products, the rinse-aid and salt lights are no longer useful. It may be
helpful to select the lowest possible setting for water hardness.
If you decide to switch to the use of a standard detergent system we advise that you:
1: Refill both the salt and rinse aid compartments.
2: Switch the water hardness setting to the highest possible position and run for three normal cycles
without a load.
3: Readjust the water hardnes s setting ag ain accor ding to the conditio ns f or your region ( For mor e
information please refer to your instruction manual).
Reset drain function
You can use Reset drain functio n to s top th e wash ing c ycle under runn ing by Rotati ng th e knob to
"Reset ", and the appliance will stop after a few minutes drain phase.
Warning
Do not place the tablets in the tub or the cutlery basket as this will result in
poorer wash results. The tablets should be placed in the detergent doser.
Cancelling or modifying a cycle
A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled ( see t he par agr aph entitled, “ Loading the
detergent ”) .
To modify a cycle that is already underway, follow the instructions contained in the paragraph entitled
"Reset drain function", and selec t t he p r ogr am me y ou wis h ( s ee t he par agr aph ent itled, "S wit c hing
the dishwasher ON").
B
A
DF
C
G
E
I
H
Notice:
The usage of 3 in 1 or similar tablets is forbidden when Heat, Rapid Wash
and Soak programmes are selected.
en