Haier DW9-TFE3, DW9-UFE3 How to fill the salt

The hardness of the water varies from place to place. If hard water is used in the dishwasher , deposit s

will form on the dishes and utensils.

The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime

and minerals from the water.

How to fill the salt

Always use salt intended for use with dishwashers.

The salt container is located beneath the lower rack and should be filled as follows:

The dishwasher is designed to allow for adjus ting the amount of salt consumed based on t he har dnes s of

the water used. This is inte nded to optimize and cust om iz e the l evel of salt consumption s o t hat it re-

mains at a minimum.

To adjust salt consumption, proceed as follows:

It is recommended that adjustments be made in accordance with the following table:

When the low salt indicator “1” lights, you must fill the salt.

Remove the lower rack and then uns c r ew and r em ov e the c ap

from the salt container;

If you are filling the container for the first time, fill it with water;

Place the end of the funnel (supplie d) into the hole and introduce

about 2 kg of salt. It is normal for a small amount of water to

come out of the salt container.

Carefully screw the cap back on.

Important

To prevent the formation of rust, load the salt just before beginning a wash cycle.

Unscrew the cap from the salt container;

There is a ring on the container with an arrow on it (see figure to

the side).

If necessary, rotate the ring in an anticlockwise di rection from the

"-" setting towards the "+" sign, based on the har dnes s of the

water being used.

Water Hardness

Clarke

degrees ºdH mmol/l Selector

position

Salt

consumption

(Grams/cycle)

Autonomy

(cycles/2kg)

0-14 0-17 0-1,7

1,8-4,418-4414-36

36-71 45-89 4,5-8,9

>89>71 >8,9

"-"

Middle

60"+"

Level