Haier FCD-HTHMG50-III(E), FCD-HTHMG60-III(E), FCD-HTHMG80-III(E), FCD-HTHMG100-III(E) Contents

Pre-safe Expert

Cleaning and Maintenance

Mark of

Haier Safe Water Heaters

Contents

Before USage

Special reminding

Features

Views and parts

Safety precautions

Setting environment

Parameters

Dimensions

Installation

Attentions in Installation

Installation

Operation

This mark is the designation for Pre-Safe Expert of Haier Water Heater Company, which indicates use of the company's patented technology inside the product. It ensures you a safe bath while monitoring whether your house ground wire is live or not all the time. If this mark is lighted on, it indicates your house ground wire has come live (poor grounding and live). In this case, please immediately stop use and unplug from the power supply, and remember not to touch any electric appliance shell in your house. At the same time, immediately contact after-sales service and your property management company for professional repair until the mark goes off.

Pre-Safe Expert will become the electric safeguard for your family.

	Control panel illustration	8
2	Remote controller panel illustration	8
2-3	Operation instructions	8-12
	Operation diagram
3
4	Attentions in operation	12
5	Use of remote controller	13
5	Electric Circuit Diagram
6
	Electric Circuit Diagram	13
6	FAQ*After service
	Cleaning and maintenance	14
7
	FAQ	14
	Packing list	14

Statement: This water heater shall only be repaired and maintained by qualified servicemen. Improper maintenance may cause severe injury or damage. Before opening or repairing water heater, please do pull out the power plug.

Note: Before asking for service, please refer to troubleshooting section to resolve easy problems.

External Cleaning: Disconnect power supply before cleaning. Gently wipe with wet cloth dipped with a little of mild detergent. Do not use gasoline or other solvents. Finally dry with dry cloth. Keep water heater dry. Do not use cleansers containing grinding agent (e.g. toothpaste), acids, chemical solvents (e.g. alcohol) or polishers to clean.

Internal Cleaning: To ensure high working efficiency, heating elements and tank liner of water heater shall be cleaned once in three years. Take care not to damage protection layer on heating elements and tank liner inner surface. According to different local water qualities and use habits, magnesium anode rod shall be periodically replaced. If maintenance is needed, please contact local service station.

FAQ

Problems	Possible Causes to be Confirmed	Corrective Measures
	If water supply is stopped or water	Check
	pressure is too low
No outlet water
	If use point is blocked or if hot water	Check and clean
	valve is open
	If water temperature is properly adjusted	Re-adjust
Outlet water is cold
	If thermostat is out of control	Contact service station
	Heating time is too short	Continue heating
Outlet water flow and	If city water pressure is steady	Check
temperature is not steady
Unable to start machine	If components are damaged	Contact service station
Error display of E1	Circuit fault	Contact service station
Error display of E2	If tank is full of water or if components	Fill water full or contact
	are damaged	service station
Error display of E3	If sensor is damaged	Contact service station

Correct Disposal of this product:

This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

See to the physical product for the appearance,color or pattern.

Packing List

Name			Expansion	Expansion	User manual		Remote
	Water Heater	Safety Valve	bolt	hook		Battery	controller	Drain hose
	(set)	(pcs)	(pcs)	(pcs)	(copy)	(pcs)	(pcs)	(ply)
Quantity	1	1	2	2	1	2	1	1