Haier HDW101WHT manual At the end of the wash cycle, Cancelling or modifying a wash cycle setting

At the end of the wash cycle...

When the buzzer constantly beeps six times, the “End” light will turn on and the cycle has finished. Turn off the appliance using the ON-OFF button, turn off the water supply and open the door of the dishwasher. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better.

Cancelling or modifying a wash cycle setting...

A cycle that is underway can only be modified if it has been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent").

Rotate the knob to the mark of “Reset” then select right programme.

Wash Cycle Adjustment Buttons

“DRY” Button

This button (see "Close-up View - Control Panel ", letter "A") when press with light wash cycle make it possible to length the drying phase.

“3 in 1” Button

This button (see "Close-up View - Control Panel", letter "B" ) , is used for the customer useing the “3 in 1” detergent.

When using "3 in 1"combination products, the rinse-aid light is no longer useful. It may be helpful there- fore to switch the rinse aid off.

Notice

Do not place the tablets in the tub or the cutlery basket as this will result in poorer wash results. The tablets should be placed in the detergent doser.

"ECO" Button

This button (see "Close-up View - Control Panel", letter "C" ) when press with normal wash cycle make

it possible to run the wash cycle at a lower temperature.

13