Haier HDY-D70-E specifications Control Panel, Program knob

Control Panel

G H I

F E D C BA J

A - Program knob

Turn this knob to choose the drying program you desire. This type of dryer has 11 program options . For description of specific programs, refer to the list of programs on Page 10. When the drying program is selected,the relevant indicator light is on.

B - Start/Pause button

Gently touch this button to start the dryer. Gently touch this button again during the operation of the dryer and the indicator light and display screen will flash and the machine will be paused .Press the button again and the program will continue .

C - Signal button

When the drying cycle has finished, an intermittent acoustic signal will sound.Touch this button,the buzzer will be canceled.

D- Anti-crease button

If this additional function is selected, the anti-crease phase at the end of the drying cycle is lengthened by 60 minutes. The laundry can be removed at any time during the anti-crease phase.

E - Delicate button

During a program, the drying temperature and power will decrease and the drying time will increase to take better care of the delicate laundry.

F- Delay button

Gently touch this button before a program starts. You may choose to start the dryer after a preset time. The delay range is between 1 and 19 hours. Every touch of the delay button will increment by one hour. When you pass 19 hours, the delay time will turn off. After a delay time is set, gently touch the Start/Pause button to the start the delay operation and the indicator light will flash.

Control Panel

G - Programme progress display

Depending on the programme selected, the drying stage reached is shown by the indicator lamps on the control panel:

- Drying

- Ready to iron

- Airing

- End/Anti-crease

At the end of a programme,the End/Anti-crease indicator lamp comes on. The drum will continue to rotate at intervals to prevent laundry creasing, if you do not wish to remove it immediately.

H - LED screen

The screen displays the remaining time for a program, the delay time and other related information.

Note: The remaining time to start a program is the default time for the program. During operation, with variation of factors such as the moisture content. The actual remaining time will be automatically adjusted until the preset drying result has been achieved and the program is complete.

I - Maintenance displays

- Empty tank

- Clean filter

- Clean condenser

Important: After each drying cycle，

–Clean the filter；

–Drain the condensed water container； (See section “Cleaning and maintenance”)

J -

D+E composite button and child lock function

During a program, press and hold down both buttons for 3 seconds to set up the child lock function if necessary. At this time, The display screen shows the remaining time and the lock alternatively, and the control panel will lock. Press and hold down both buttons for 3 seconds once again and the child lock will release.When the program is end or the power off during the program, the child lock will release.

8 9