Haier 001050, HSU-09LH13, HSU-12LH13 operation manual Parts and Functions, Clock Set

Models: 001050 HSU-12LH13 HSU-09LH13

1 24
Download 24 pages 16 Kb
Page 8
Image 8
 Clock Set

Parts and Functions

Manual background Clock Set

When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows:

1.Press CLOCK button,"AM" or "PM" flashes.

2.PressManual background orManual background to set correct time. Each press will increase or decrease

1min. If the button is kept depressed, time will change quickly.

3.After time setting is confirmed, press SET, "AM" or "PM" stop flashing, while clock starts working.

FRESH

STERILIZE

Manual background Remote controller's operation

Manual background When in use, put the signal transmission head directly to the receiver hole on the indoor unit.

Manual backgroundThe distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well.

Manual background Don't throw or knock the remoter controller.

Manual background When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wireless telephone is installed in the room, the receiver is apt to be disturbed in receiving the signals, so the distance to the indoor unit should be shorter.

Loading of the battery

Load the batteries as illustrated right 2 R-03 (7#) batteries

Remove the battery cover:

Slightly press" Manual background "area and push down the cover as illustrated.

Load the battery:

Be sure that the loading is in line with the "+" / "-". request as illustrated on the bottom of the case.

Put on the cover again.

Confirmation indicator:

After pressing power ON/OFF, if no display, reload the batteries.

Note:

Manual background Full display or unclear display during operation indicates the batteries have been used up. Please change batteries.

Manual background Used two new same-typed batteries when loading.

Manual background If the remote controller can't run normally during operation, please remove the batteries and reload several minutes later.

Hint:

Remove the batteries in case unit won't be in usage for a long period. If there are any display after taking-out, just need to press reset key.

7

Page 8
Image 8
Haier 001050, HSU-09LH13, HSU-12LH13 operation manual Parts and Functions, Clock Set