Haier HWM60-113S user manual Disposal after washing, Cleaning the lint filter

Water inlet hose

Disposal after washing

After using, please clean the lint and eyewrinker of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning.

Cleaning the lint filter

The lint filter must be used during washing.

It must be cleaned in time after each using.

1. Take off the lint filter

Put hand at the indicated position. Push down to take it off. ( See

How to change the direction of the drain hoses

Figure 1 indicates the ex factory installation		Back
position of the drain hose.	Soft item
Extend the drain hose from the side of spin tub		Front

Put soft items on the ground. Lean the machine		Figure 1
down gently with the front surface facing the
ground. Take off the drain hose from the cabinet.
Take the hose out of the fixing groove.
(See to Figure 2).
Embed the drain hose into the groove along the	Soft item	Figure 2
side of the spin tub in the order of (1)~(3), heading
for the side of the spin tub. (See to Figure 3).

Figure 1)

2. Clean the lint

Figure 1

Embed the drain hose into the groove with

hands. Take care not to damage the drain

hose in fastening the fixing clamp.

Put it in water and clean while it is still wet.(See Figure 2)

3. Install the lint filter

After cleaning, insert the bottom Figure 2 of the lint filter ( marked with

"down side") into the overflow filter , then push the upper part of the

Extend the drain hose from the rear side	Extend to the
	spin tub side

Take out the drain hose from the fixing groove. Extend it fromthe rear side as per the direction of the arrow. (When the drainhose is extended from the rear side, it can be hung on the point for drain hose at the two sides of the cabinet.) (See to Figure 4).

Embed into the groove in turn

Figure 3

Figure 4

filter in ( marked with " up side ").

(See Figure 3)

Figure 3

Install the water inlet hose; Select the water level

Cleaning the overflow filter

Too much lint on the overflow filter will influence the normal usage of the machine. Please

clean it every two months.

Elastic fixing

Insert the water inlet hose into the water-filling entrance, then push the water-filling jointer into the wash water-filling entrance on the major frame.(To dismantle the water inlet pipe, just push the control handle

as indicated in the figure and pull it out)

Push	Water-filling jointer
Control handle	Wash water-filling entrance

Water level indicator

1 Take off the overflow filter.claw As indicated in the figure, nip the elastic fixing

claw and pull it to the direction of the arrow to take it off.

Select water level according to the
quantity of the laundries.	Maximum Max
Set the water level adjusting lever	about 43L	Med
	Medium
to needed line.
	about 36L	Min
	Minimum

about 30L

12 5