External Equipment Connections
Choose Your Connection |
| on the remote control, and then press 5/6button to | |
|
| select the source, press the button to confirm. | |
There are several ways to connect your television, |
|
| |
depending on the components you want to connect and |
|
| |
DVD Setup | |||
the quality of the signal you want to achieve. | |||
The following are examples of someways to connect |
|
| |
your TV. Choose the connection which is best for you. |
|
| |
| How to connect | ||
VCR Connection | |||
|
| ||
A Connect the DVD video outputs (Y, Pb/Cb, Pr/Cr) | |||
| |||
| |||
To avoid picture noise (interference), leave an adequate |
| to the COMPONENT (Y, Pb/Cb, Pr/Cr) input jacks on | |
distance between the VCR and TV. |
| the TV and connect the DVD audio outputs to the | |
|
| AUDIO jacks on the TV’ as shown in the figure. | |
COMPONENT IN 
AV1 |
OUT |
AIf your DVD only has an
COMPONENT IN |
AV1 |
OUT |
Connection Option 1
Set VCR output switch to channel 3 or 4 and then tune the TV to the same channel number.
Note
If your DVD player dose not have component video output,use
Connection Option 2
AConnect the audio and video cables from the VCR’s output jacks to the TV input jacks, as shown in the figure. When connecting the TV to VCR, match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red). If you connect a
BInsert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner’s manual.)
CSelect the input source with using the SOURCE button
How to use
ATurn on the DVD player, insert a DVD.
BUse the SOURCE button on the remote control,and then press 5/6button to to select COMPONENT mode, press the button to confirm.
CPress Play button on external equipment for program play.
DRefer to the DVD player’s manual for operating instructions.
HDMI or DVI Setup
10 TFT
