Resetting the Standard Product Default Settings: Current Application Work Group

If you aren’t sure what programming options are in your scanner, or you’ve changed some options and want the standard product default settings restored, scan the Standard Product Default Settings: Current Application Group bar code below.

The Menu Commands starting on page 10-6list the factory default settings for each of the commands (indicated by an asterisk (*) on the programming pages).

Note: Scanning this bar code also causes both the scanner and the base to perform a reset and become unlinked. Refer to "Linking Scanner to Base" on page 1-6for additional information.

Standard Product Default Settings:

Current Application Group

Note: If your scanner is in multiple scanner mode and you scan either the current or all application group default bar code, you will hear up to 30 seconds of beeping while all scanners are re-linked from the base and the settings are defaulted to * settings. The default interface is keyboard wedge and the default scanner mode is single scanner locked link mode.

Resetting the Standard Product Default Settings: All Application Work Groups

The following bar code defaults all of the work groups to the factory settings.

Standard Product Default Settings:

All Application Groups

The Menu Commands starting on page 10-6list the standard product default settings for each of the commands (indicated by an asterisk (*) on the programming pages).