Hand Held Products 3820 Changing Scanner Name - via Bar Codes, Reset, Scanner Name, bar code on the, Programming Chart, Save, Reset

Changing Scanner Name - via Bar Codes

If you wanted to set up your scanners with names 0001-0007, you may scan the bar codes below. Scan the Reset bar code after each name change and wait for the scanner to re-link to the base before scanning the next bar code to name the next scanner.

0001

0002

0003

0004

0005

0006

0007

Reset

Alternatively, you may change the name with a bar code command if you cannot send serial commands to the base. One way to do this is to scan the bar code below and scan a number for the scanner name. For example, if you had 7 scanners to one base, scan the bar code below with the first scanner, scan the

1bar code on the Programming Chart inside the back cover of this manual and scan Save. Then scan the Reset bar code and wait for the scanner to re-link to the base before scanning the next bar code. Repeat that process for scanner number 2, 3, 4 etc.

Scanner Name

If you want to assign an alphabetic name to the scanner, create a Code 128 bar code containing “~BT_NAMname.” followed by a FNC3 character (hexidecimal 83), where name is the new scanner name. Scan the Reset bar code (page 1-9or on the Programming Chart inside the back cover of this manual). You may use Barcode Builder, which is included with Quick*View. You may download Quick*View from the Hand Held Products website: www.handheld.com.

2020/3820 User’s Guide 1 - 9