OPERATION
1.Make sure the Power Switch is in the “OFF” position. (See Figure M.)
2.Attach the heavy duty hose to the Pressure Washer, using the Quick Connector Set (36C). (See Figure G.)
3.Attach the Spray Wand (9C), Turbo Wand (33C), or Brush Wand and Adapter (34C, 35C) into the Spray Wand Extension (8C), and press and twist the Wand into the Extension until the Wand locks in place. (See Figures E and F.)
NOTE: The Pressure Washer will not pressurize if the Nozzle is not completely assembled. It will not work properly with only part of the Wand installed.
4.Connect the High Pressure Hose (24C) to the Pressure Washer. (See Figure G.) Make sure all connections are tight. Then, open the water supply valve fully. If leaks occur, shut off water and retighten connections.
5. | IMPORTANT! Prior to |
| POWER SWITCH |
| turning on the Pressure |
| |
|
| (Illuminates while | |
| Washer, connect the unit |
| on.) |
| to the water supply. Turn |
|
|
| on the water, disengage |
|
|
| the safety, and squeeze the |
|
|
| Trigger (21C) until water |
|
|
| flows out of the Wash Gun |
|
|
| (5A). This removes air from |
|
|
| the system and allows the |
|
|
| unit to properly perform. |
|
|
| Failure to follow this step |
|
|
| can damage the Pump. |
|
|
6. | Test the cleaning capabilities |
| FIGURE M (REAR VIEW) |
| and the run before starting |
| |
| your cleaning project, as |
|
|
|
|
| |
| explained on page 17, #1. Turn the Power Switch to the “ON” position, it should | ||
| illuminate. The motor will briefly run when the switch is first turned on to build | ||
| up pressure and then go to standby until the trigger is squeezed. | ||
| NOTE: The Motor (3A) does not run continuously, but only when the Trigger is | ||
| squeezed. If a humming noise persists while the motor is on standby, briefly | ||
| discharge the nozzle in a safe direction. |
|
7.Point the Nozzle in a safe direction. Then, disengage the Safety and squeeze the Trigger (21C). Switch the unit’s switch to the OFF position whenever the gun is not in use. (See Figures I and M.) Clean the area, following the tips contained in the Operating Tips section.
8.When finished spraying, fully engage the Trigger Safety Lock (26C), turn the Power Switch to its “OFF” position, and turn off the water supply. (See Figure M.)
SKU 02433 | For technical questions, please call | PAGE 15 | |
Troubleshooting section at end of manual. | |||
|
|