Cutting
Caution: Verify that saw blade is securely tightened and both angle and height adjusting knobs are tight.
1.If desired for a straight cut, slide the Rip Guide (402) into the side of the Circular Saw and tighten with Wing Bolt (58), or clamp a straight edge to the material to guide the saw on a straight path.
2.Place the saw Base Assy. on the material to be cut. Align the front notch (right edge aligns with saw blade) on the cut line.
3.Hold the Circular Saw by both handles.Always keep hands and fingers away from the Saw Blade.
4.Squeeze the trigger Switch (12) with the index finger. Do this before the saw blade touches the material.
5.With the saw at full speed, move the saw slowly forward to complete the cut.
6.When the cut in complete, release the trigger Switch. Do not set the saw down until the blade stops turning.
INSPECTION, MAINTENANCE, AND CLEANING
1.
WARNING! Make sure the Power Switch (part #12) of the Circular Saw is in its “OFF” position and that the tool is unplugged from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
2.BEFORE EACH USE, inspect the general condition of the Circular Saw. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected be- fore further use. Do not use damaged equipment.
3.Before remounting the saw blade, remove all sawdust that has accumulated around the safety guard.
4.Regularly inspect and tighten all mounting screws and knobs.
5.Keep saw blades clean and sharp. Sharp blades minimize stalling and kickback.
6.Keep guards in good working order.
7.Keep motor air vent clean of dust and debris. Vacuum periodically.
8.If the tool is not operating normally, making unusual noises, or appears defective, stop using it immediately and get it repaired.
9.Clean tool with a damp cloth and light detergent. Do not use solvents as they can damage and crack the plastic parts.
SKU 47613 | Page 12 |
