Harbor Freight Tools 65761 manual Technical Specifications, Servicing, To prevent serious injury

Technical

Specifications

		9 HP, Air Cooled, Single
Engine Type		Cylinder, 4 Stroke
		Overhead Valve
Engine Family		8CGPS.2702GC.
Displacement		270cc
Rotation viewed from PTO		Counterclockwise
(power takeoff - the output shaft)
	Type	89+ octane unleaded
Fuel		gasoline
	Capacity	1.2 Gallons
		10W30 (above 32° F)
Engine Oil	Type	5W30 (at 32° F or
		below)
	Capacity	1.1 Quarts
Spark Plug	Type	F7RTC
	Gap	0.028 - 0.031”
Valve	Intake	.005” - .007”
Clearance	Exhaust	.007” - .009”
Speed	Idle	1,600 RPM
	Maximum	2,600 RPM

Servicing

To prevent serious injury

from accidental starting:

Turn the Power Switch of the equipment to its “OFF” position, wait for the engine to cool, and disconnect the spark plug wire(s) before performing any inspection, maintenance, or cleaning procedures.

To prevent serious injury

from equipment failure: Do not use damaged equipment. If abnormal noise, vibration, or excess smoking occurs, have the problem corrected before further use.

Maintenance Procedures

Many maintenance procedures, including those not detailed in this manual, will need to

be performed by a qualified technician for safety. If you have any doubts about your ability to safely service the equipment or engine, have a qualified technician service the equipment instead.

Note: Warranty is void if proper mainte- nance and servicing procedures are not followed.

Engine Oil Change

CAUTION! Oil is very hot during opera- tion and can cause burns. Wait for engine to cool before changing oil.

1.Place a drain pan (not included) un- derneath the crankcase’s drain plug.

2.Remove the drain plug and, if pos- sible, tilt the crankcase slightly to help drain the oil out. Recycle used oil.

3.Replace the drain plug (and gasket, if supplied) and tighten it.

4.Refill the oil to the proper level follow- ing the instructions under the Starting the Engine section.

SKU 65761 For technical questions, please call 1-800-444-3353. Page 15